27 October 2021

Bedding cart

THE MODERN WAY TO SPREAD BEDDING

The Bedding cart is available in two models: 940 – 51 cu. ft. with a 13 Hp motor / 970-70 cu. ft. with a 13 Hp motor, similar to Supercart 542 and 975 – fully welded frame and body for more rigidity to withstand tough conditions.

2 or 4 drive wheels, depending on the model.
The unloading auger is located at the rear end of the cart, closer to the driver for easier visual access.

FEATURES

SIMPLE 

Two spring loaded adjusting bolts are used to insure a good tension on the conveyor.

TENSION

The tension of the conveyor is ensured by 2 springs mounted on adjustable rods on each side of the box towards the front of the machine.

PERFORMANCE 

The hydrostatic transmission and the hydraulic pump are directly driven by the Honda engine, no belt. Less maintenance, more power.

IMPELLER

Two heavy-duty TMR-type beaters regulate the quantity of material going to the discharge auger. The chopped straw or saw dust can then either drop next to the cart or be spread using the powerful 18” impeller. The impeller can spread evenly up to 8’ away from the cart.

POWERFUL

The bedding cart is equipped with a Honda GX270 9 HP with electric starter on the step for easier fueling.

HAND-LEVER

The impeller is easily positioned in place using a hand- lever. This way, when not needed, it is possible to « hide » the impeller under the cart (for narrower spaces, to use the cart without the impeller,…)

PUMP & TRANSMISSION

Hydraulic pump and hydrostatic transmission.

 

TOUGHER 

The drive wheels are mounted on wheels motors for less maintenance and more power (No axle!).

 CONTROL VALVE 

The powerful hydraulic pump supplies power to a grouped control valve to separately operate and control the variable flow of the conveyor (deck), beaters and propeller.